![]() ![]() The mod is a patch on the libFAT module to allow Ustealth on emuNAND (partial and Full, not neek). I recommend installing the cIOS d2x v10 r52 " libFAT mod", with base57 in slot249 for better compatibility. (I always recommend SD card for homebrew resources, loads faster and more stable) the USBLoaderGX boot.dol on either SD or USB. the vWii UNEO forwarder, which will then launche the boot.dol on your SD cardģ. (you'll be in vWii mode, USB will work using cIOS d2x v10*, and of course you will not have gamepad support in games)Ģ. the WiiU forwarder to vWii HBC, patched to load UNEO instead of HBC. You'll have to install two different forwarder :ġ. 100GB partition for Gamecube and 900GB for Wii. 1TBHDD for the VWii, with Ustealth ran on it. 500GB HDD for the Wii U in a powered 3.0 hub, one USB in the front. What you want is a WiiU "vWii launcher" channel, and not a WiiU "WiiVC injected" channel. 32GB Wii U with Nintendont forwarder on the NAND, USBLoaderGX forwarder is installed on the USB HDD. WiiU VC runs in WiiU mode, it lets you use the gamepad, but can't access USB. A lot of options are available and directly editable from the. Its interface, based on the official theme from Nintendo Wii, is easy to use and perfect for kids and all the family. It allows listing and launching Wii games, Gamecube games and homebrew on Wii and WiiU vWii mode. The WiiU VCWii channels are using a special cIOS (255) which cannot read USB. USBLoaderGX is a GUI for Waninkoko's USB Loader, based on libwiigui. When launched from wiiU, there's no USB Access ! No I don't want to install forwarders for each game either. I've been stuck on this for the entire day. The moments I am able to access the menu I've tried all the IOSes I've seen online with no dice, occasionally the games did show up with ones like 249 or 82 but the games clearly weren't loading as it booted me back to the home menu on launch. I was once able to load a Wii game, but upon return to the Loader all of the games on the HDD disappeared and the drive wasn't initialized. I have an issue where it freezes on initializing a usb device no matter what port I use. I ideally want to run USBLoaderGX from the Wii U home menu, and play a game from the Wii, or the Gamecube (with a Gamecube Controller Adapter) Clearly there's no HDD issue, the issue seems to be on USBLoaderGX's end. USB obviously doesn't work as it's a VC game.īut in Vwii it works perfectly too, with both the Ustealthed HDD and SD. Ustealth is setup on the VWii's HDD too.įirst I run the Nintendont forwarder, works perfectly with the Wii U Gamepad. ![]() This worked perfectly on my original Wii console, and is the same setup. 1TBHDD for the VWii, with Ustealth ran on it.500GB HDD for the Wii U in a powered 3.0 hub, one USB in the front.32GB Wii U with Nintendont forwarder on the NAND, USBLoaderGX forwarder is installed on the USB HDD. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |